Reloop MIXAGE Bedienerhandbuch PDF herunterladen (Seite 53)





CD2 CUE2 SW/LED 18/18 57/18

CD2 CUE3 SW/LED 19/19 58/19

CD2 CUE4 SW/LED 1A/1A 59/1A

CD2 LOAD SW/LED 1B/1B 5A/1B

CD2 HP SW/LED 1C/1C 5B/1C

CH1 Level Meter LEVEL 1D 0~7

CH2 Level Meter LEVEL 1E 0~7

CD1 LOAD SW/LED 0D/0D 4C/0D

CD1 HP SW/LED 0E/0E 4D/0E

CD2 - SW/LED 0F/0F 4E/0F

CD2 + SW/LED 10/10 4F/10

CD2 Search SW/LED 11/11 50/11

CD2 Scratch SW/LED 12/12 51/12

CD2 LOOP SW/LED 13/13 52/13

CD2 RELOOP SW/LED 14/14 53/14

CD2 FX SEL SW/LED 15/15 54/15

CD2 FX ON SW/LED 16/16 55/16

CD2 CUE1 SW/LED 17/17 56/17



Control Change messages are sent with status 0xBn, where n is the channel, for the specied CC

controller. Thus the controller MIDI ID is indicated with the channel along with the CC number. The

value from 0x00 to 0x7F, directly related to the location of the controller.



Control Change messages are status 0xBn, where n is the channel, for the specied CC controller.

Thus the controller MIDI ID is indicated with the channel along with the CC number. The value from

0x40 to indicate the change in the controller. This is an offset to 0x40 “one’s complement” notation.

A message with data 0x43 indicates a positive change of 3.

A messages with data 0x31 indicates a negative change of 15.



These messages are used for switches.

Control Change messages are sent with status 0x9n, SWITCH On and Off value are 0x7F and 0x00,

where n is the channel.



These messages are used for LED.

Control Change messages are sent with status 0x9n, LED On and Off value are 0x7F and 0x00,

where n is the channel.



Pitchbend messages are status 0xEn, where n is the channel, for the specied controller.

Thus the controller ID is indicated only by the channel.

For accurate changes, the 14 bit data in a pitch bend message is reserved for absolute controllers

which require more than 7 bits of data.



These messages are used for LEVEL.

Control Change messages are sent with status 0x9n, LED Off value is 0x00 and On value is related

to LED amount, 0x01 with one LED, 0x02 with two LED…., where n is the channel.

1 2 ... 48 49 50 51 52 53 54 55 56

Kommentare zu diesen Handbüchern

Keine Kommentare

Reloop MIXAGE Bedienerhandbuch Seite 53

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Aufnahmegeräte Reloop MIXAGE